Five points determine a conic

This article is about Water activity in food science. For a more general discussion, see thermodynamic activity.

Water activity or a_w was developed to account for the intensity with which water associates with various non-aqueous constituents and solids. Simply stated, it is a measure of the energy status of the water in a system.

Water activity is defined as the partial vapor pressure of water in a substance divided by the standard state partial vapor pressure of water. In the field of food science, the standard state is most often defined as the partial vapor pressure of pure water at the same temperature. Using this particular definition, pure distilled water has a water activity of exactly one.

As the temperature increases, a_w typically increases, except in some products with crystalline salt or sugar.

Higher a_w substances tend to support more microorganisms. Bacteria usually require at least 0.91, and fungi at least 0.7. See also fermentation.

Water migrates from areas of high a_w to areas of low a_w. For example, if honey (a_w ≈ 0.6) is exposed to humid air (a_w ≈ 0.7), the honey will absorb water from the air. If salami (a_w ≈ 0.87) is exposed to dry air (a_w ≈ 0.5), the salami will dry out, which could preserve it or spoil it.

Formulae

Definition of a_w:

$a_{w}\equiv p/p_{0}$

where p is the vapor pressure of water in the substance, and p₀ is the vapor pressure of pure water at the same temperature.

Alternate definition:

$a_{w}\equiv l_{w}x_{w}$

where l_w is the activity coefficient of water and x_w is the mole fraction of water in the aqueous fraction.

Relationship to relative humidity: The relative humidity of air in equilibrium with a sample is called the Equilibrium Relative Humidity (ERH).

$\mathrm {ERH} =a_{w}\times 100\%$

Estimated mold-free shelf life in days at 21° C:

$\mathrm {MFSL} =10^{7.91-8.1a_{w}}$

Uses for water activity

Water activity is an important consideration for food product design and food safety.

Food product design

Food designers use water activity to formulate shelf-stable food. If a product is kept below a certain water activity, then mold growth is inhibited. This results in a longer shelf life.

Water activity values can also help limit moisture migration within a food product made with different ingredients. If raisins of a higher water activity are packaged with bran flakes of a lower water activity, the water from the raisins will migrate to the bran flakes over time, resulting in hard raisins and soggy bran flakes. Food formulators use water activity to predict how much moisture migration will affect their product.

Food safety

Water activity is used in many cases as a critical control point for Hazard Analysis and Critical Control Points (HACCP) programs. Samples of the food product are periodically taken from the production area and tested to ensure water activity values are within a specified range for food quality and safety. Measurements can be made in as little as five minutes, and are made regularly in most major food production facilities.

For many years, researchers tried to equate bacterial growth potential with water content. They found that the values were not universal, but specific to each food product. W. J. Scott first established that bacterial growth correlated with water activity, not water content, in 1953. It is firmly established that growth of bacteria is inhibited at specific water activity values. U.S. Food and Drug Administration (FDA) regulations for intermediate moisture foods are based on these values.

Lowering the water activity of a food product should not be seen as a kill step. Studies in powdered milk show that viable cells can exist at much lower water activity values, but that they will never grow.Template:Cn Over time, bacterial levels will decline.

Water activity measurement

Water activity values are obtained by either a resistive electrolytic, a capacitance or a dew point hygrometer.

Resistive electrolytic hygrometers

Resistive electrolytic hygrometers respectively sensors consist of a sensing element in form of a liquid electrolyte which is held in between of two small glass rods by capillary forces. The electrolyte changes its resistance if water vapor is absorbed or desorbed. The resistance is directly proportional to relative air humidity and also to water activity of the sample once vapor–liquid equilibrium has been established. This relation can be checked on a regular base by either a verification or calibration using salt-water mixtures which provide a well-defined and reproducible air humidity in the measurement chamber.

The sensor does not have any physically given hysteresis as it is known from capacitance hygrometers and sensors, and does not require regular cleaning as its surface is not the effectively sensing element. Volatiles have in principle an influence on the measurement performance, especially those which dissociate in the electrolyte and thereby change its resistance. Such influences can easily be avoided by using chemical protection filters which absorb the volatile compound before arriving at the sensor.

Capacitance hygrometers

Capacitance hygrometers consist of two charged plates separated by a polymer membrane dielectric. As the membrane adsorbs water, its ability to hold a charge increases and the capacitance is measured. This value is roughly proportional to the water activity as determined by a sensor-specific calibration.

Capacitance hygrometers are not affected by most volatile chemicals and can be much smaller than other alternative sensors. They do not require cleaning, but are less accurate than dew point hygrometers (+/- 0.015 a_w). They should have regular calibration checks and can be affected by residual water in the polymer membrane (hysteresis).

Dew point hygrometers

Red line shows saturation

The temperature at which dew forms on a clean surface is directly related to the vapor pressure of the air. Dew point hygrometers work by placing a mirror over a closed sample chamber. The mirror is cooled until the dew point temperature is measured by means of an optical sensor. This temperature is then used to find the relative humidity of the chamber using psychrometrics charts.

This method is theoretically the most accurate (+/- 0.003 a_w) and often the fastest. The sensor requires cleaning if debris accumulates on the mirror.

Equilibration

With either method, vapor–liquid equilibrium must occur in the sample chamber. This will take place over time or can be aided by the addition of a fan in the chamber. Thermal equilibrium must also take place unless the sample temperature is measured.

Moisture content

Water activity is related to water content in a non-linear relationship known as a moisture sorption isotherm curve. These isotherms are substance- and temperature-specific. Isotherms can be used to help predict product stability over time in different storage conditions.

Use in humidity control

There is net evaporation from a solution with a water activity greater than the relative humidity of its surroundings. There is net absorption of water by a solution with a water activity less than the relative humidity of its surroundings. Therefore, in an enclosed space, a solution can be used to regulate humidity.

Selected a_w values

Food

Substance	aw	Source
Distilled Water	1.00
Tap water	0.99	Template:Cn
Raw meats	0.99
Milk	0.97	Template:Cn
Juice	0.97	Template:Cn
Salami	0.87
Cooked bacon	< 0.85	Template:Cn
Saturated NaCl solution	0.75	Template:Cn
Point at which cereal loses crunch	0.65	Template:Cn
Dried fruit	0.60
Typical indoor air	0.5 - 0.7	Template:Cn
Honey	0.5 - 0.7	Template:Cn

+Microorganisms

Microorganism Inhibited	aw	Source
Clostridium botulinum A, B	0.97	Template:Cn
Clostridium botulinum E	0.97	Template:Cn
Pseudomonas fluorescens	0.97	Template:Cn
Clostridium perfringens	0.95	Template:Cn
Escherichia coli	0.95	Template:Cn
Salmonella	0.93
Vibrio cholerae	0.95	Template:Cn
Bacillus cereus	0.93	Template:Cn
Listeria monocytogenes	0.92	Template:Cn
Bacillus subtilis	0.91	Template:Cn
Staphylococcus aureus	0.86
Most molds	0.80
No microbial proliferation	0.50	Template:Cn

Notes

43 year old Petroleum Engineer Harry from Deep River, usually spends time with hobbies and interests like renting movies, property developers in singapore new condominium and vehicle racing. Constantly enjoys going to destinations like Camino Real de Tierra Adentro.

References

• 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.
  
  My blog: http://www.primaboinca.com/view_profile.php?userid=5889534
• 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.
  
  My blog: http://www.primaboinca.com/view_profile.php?userid=5889534
• 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.
  
  My blog: http://www.primaboinca.com/view_profile.php?userid=5889534
• 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.
  
  My blog: http://www.primaboinca.com/view_profile.php?userid=5889534
• 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.
  
  My blog: http://www.primaboinca.com/view_profile.php?userid=5889534
• 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.
  
  My blog: http://www.primaboinca.com/view_profile.php?userid=5889534

External links

• Moisture in Oil Sensors
• Dew Point Sensors