Linkage (mechanical): Difference between revisions

From formulasearchengine
Jump to navigation Jump to search
en>VolkovBot
m r2.7.2) (Robot: Adding ar:رابط ميكانيكي
 
No edit summary
Line 1: Line 1:
<br><br>It is very common to have a dental emergency -- a fractured tooth, an abscess, or severe pain when chewing. Over-the-counter pain medication is just masking the problem. Seeing an emergency dentist is critical to getting the source of the problem diagnosed and corrected as soon as possible.<br><br>Here are some common dental emergencies:<br>Toothache: The most common dental emergency. This generally means a badly decayed tooth. As the pain affects the tooth's nerve, treatment involves gently removing any debris lodged in the cavity being careful not to poke deep as this will cause severe pain if the nerve is touched. Next rinse vigorously with warm water. Then soak a small piece of cotton in oil of cloves and insert it in the cavity. This will give temporary relief until a dentist can be reached.<br><br>At times the pain may have a more obscure location such as decay under an old filling. As this can be only corrected by a dentist there are two things you can do to help the pain. Administer a pain pill (aspirin or some other analgesic) internally or dissolve a tablet in a half glass (4 oz) of warm water holding it in the mouth for several minutes before spitting it out. DO NOT PLACE A WHOLE TABLET OR ANY PART OF IT IN THE TOOTH OR AGAINST THE SOFT GUM TISSUE AS IT WILL RESULT IN A NASTY BURN.<br><br>Swollen Jaw: This may be caused by several conditions the most probable being an abscessed tooth. In any case the treatment should be to reduce pain and swelling. An ice pack held on the outside of the jaw, (ten minutes on and ten minutes off) will take care of both. If this does not control the pain, an analgesic tablet can be given every four hours.<br><br>Other Oral Injuries: Broken teeth, cut lips, bitten tongue or lips if severe means a trip to a dentist as soon as possible. In the mean time rinse the mouth with warm water and place cold compression the face opposite the injury. If there is a lot of bleeding, apply direct pressure to the bleeding area. If bleeding does not stop get patient to the emergency room of a hospital as stitches may be necessary.<br><br>Prolonged Bleeding Following Extraction: Place a gauze pad or better still a moistened tea bag over the socket and have the patient bite down gently on it for 30 to 45 minutes. The tannic acid in the tea seeps into the tissues and often helps stop the bleeding. If bleeding continues after two hours, call the dentist or take patient to the emergency room of the nearest hospital.<br><br>Broken Jaw: If you suspect the patient's jaw is broken, bring the upper and lower teeth together. Put a necktie, handkerchief or towel under the chin, tying it over the head to immobilize the jaw until you can get the patient to a dentist or the emergency room of a hospital.<br><br>Painful Erupting Tooth: In young children teething pain can come from a loose baby tooth or from an erupting permanent tooth. Some relief can be given by crushing a little ice and wrapping it in gauze or a clean piece of cloth and putting it directly on the tooth or gum tissue where it hurts. The numbing effect of the cold, along with an appropriate dose of aspirin, usually provides temporary relief.<br><br>In young adults, an erupting 3rd molar (Wisdom tooth), especially if it is impacted, can cause the jaw to swell and be quite painful. Often the gum around the tooth will show signs of infection. Temporary relief can be had by giving aspirin or some other painkiller and by dissolving an aspirin in half a glass of warm water and holding this solution in the mouth over the sore gum. AGAIN DO NOT PLACE A TABLET DIRECTLY OVER THE GUM OR CHEEK OR USE THE ASPIRIN SOLUTION ANY STRONGER THAN RECOMMENDED TO PREVENT BURNING THE TISSUE. The swelling of the jaw can be reduced by using an ice pack on the outside of the face at intervals of ten minutes on and ten minutes off.<br><br>To find out more information in regards to [http://www.youtube.com/watch?v=90z1mmiwNS8 Dentists in DC] review our own web page.
An '''optical medium''' is material through which [[electromagnetic wave]]s propagate.  It is a form of [[transmission medium]]. The  [[permittivity]] and [[Permeability (electromagnetism)|permeability]] of the medium define how electromagnetic waves propagate in it. The medium has an ''[[intrinsic impedance]]'', given by
::<math>\eta = {E_x \over H_y}</math>
where <math>E_x</math> and <math>H_y</math> are the [[electric field]] and [[magnetic field]], respectively.
In a region with no [[electrical conductivity]], the expression simplifies to:
 
::<math>\eta = \sqrt{\mu \over \varepsilon}\ .</math>
 
For example, in [[free space]] the intrinsic impedance is called the [[characteristic impedance of vacuum]], denoted ''Z''<sub>0</sub>, and
 
::<math>Z_0 = \sqrt{\mu_0 \over \varepsilon_0}\ .</math>
 
Waves propagate through a medium with velocity <math>c_w = \nu \lambda </math>, where <math>\nu</math> is the [[frequency]] and <math>\lambda</math> is the [[wavelength]] of the electromagnetic waves. This equation also may be put in the form
:<math> c_w = {\omega \over k}\ ,</math>
where <math>\omega</math> is the [[angular frequency]] of the wave and <math>k</math> is the [[wavenumber]] of the wave. In [[electrical engineering]], the symbol <math>\beta</math>, called the ''[[phase constant]]'', is often used instead of <math>k</math>.
 
The propagation velocity of electromagnetic waves in [[free space]], an idealized standard reference state (like [[absolute zero]] for temperature), is conventionally denoted by ''c''<sub>0</sub>:<ref>With [[ISO 31-5]], [[NIST]] and the [[BIPM]] have adopted the notation ''c''<sub>0</sub>.</ref>  
:<math>c_0 = {1 \over \sqrt{\varepsilon_0 \mu_0}}\ ,</math>
:where <math>\varepsilon_0</math> is the [[electric constant]] and <math>~ \mu_0 \ </math> is the [[magnetic constant]].
 
For a general introduction, see Serway<ref name=Serway>
{{cite book
|author=Raymond Serway & Jewett J
|title=Physics for scientists and engineers
|edition=6th Edition
|year= 2003
|publisher=Thomson-Brooks/Cole
|location=Belmont CA
|isbn=0-534-40842-7
|url=http://worldcat.org/isbn/0-534-40842-7}}
</ref> For a discussion of man-made media, see Joannopoulus.<ref name=Joannopoulos>
{{cite book
|author=John D Joannopouluos, Johnson SG, Winn JN & Meade RD
|title=Photonic crystals : molding the flow of light
|edition=2nd Edition
|year= 2008
|publisher=Princeton University Press
|location=Princeton NJ
|isbn=978-0-691-12456-8
|url=http://ab-initio.mit.edu/book/}}
</ref>
==Notes and references==
 
{{Reflist}}
 
==See also==
*[[Čerenkov radiation]]
*[[Electromagnetic spectrum]]
*[[Electromagnetic radiation]]
*[[Optics]]
*[[SI units]]
*[[Free space]]
*[[Metamaterial]]
*[[Photonic crystal]]
*[[Photonic crystal fiber]]
 
 
 
[[Category:Optics|Medium]]
[[Category:Electric and magnetic fields in matter|Medium]]

Revision as of 17:08, 14 January 2014

An optical medium is material through which electromagnetic waves propagate. It is a form of transmission medium. The permittivity and permeability of the medium define how electromagnetic waves propagate in it. The medium has an intrinsic impedance, given by

η=ExHy

where Ex and Hy are the electric field and magnetic field, respectively. In a region with no electrical conductivity, the expression simplifies to:

η=με.

For example, in free space the intrinsic impedance is called the characteristic impedance of vacuum, denoted Z0, and

Z0=μ0ε0.

Waves propagate through a medium with velocity cw=νλ, where ν is the frequency and λ is the wavelength of the electromagnetic waves. This equation also may be put in the form

cw=ωk,

where ω is the angular frequency of the wave and k is the wavenumber of the wave. In electrical engineering, the symbol β, called the phase constant, is often used instead of k.

The propagation velocity of electromagnetic waves in free space, an idealized standard reference state (like absolute zero for temperature), is conventionally denoted by c0:[1]

c0=1ε0μ0,
where ε0 is the electric constant and μ0 is the magnetic constant.

For a general introduction, see Serway[2] For a discussion of man-made media, see Joannopoulus.[3]

Notes and references

43 year old Petroleum Engineer Harry from Deep River, usually spends time with hobbies and interests like renting movies, property developers in singapore new condominium and vehicle racing. Constantly enjoys going to destinations like Camino Real de Tierra Adentro.

See also

  1. With ISO 31-5, NIST and the BIPM have adopted the notation c0.
  2. 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.

    My blog: http://www.primaboinca.com/view_profile.php?userid=5889534
  3. 20 year-old Real Estate Agent Rusty from Saint-Paul, has hobbies and interests which includes monopoly, property developers in singapore and poker. Will soon undertake a contiki trip that may include going to the Lower Valley of the Omo.

    My blog: http://www.primaboinca.com/view_profile.php?userid=5889534