General ledger: Difference between revisions

From formulasearchengine
Jump to navigation Jump to search
en>SchreiberBike
Repairing links to disambiguation pages - You can help! - Loss
 
en>Well-rested
added accounting template and refimprove
Line 1: Line 1:
<br><br>It is very common to have a dental emergency -- a fractured tooth, an abscess, or severe pain when chewing. Over-the-counter pain medication is just masking the problem. Seeing an emergency dentist is critical to getting the source of the problem diagnosed and corrected as soon as possible.<br><br>Here are some common dental emergencies:<br>Toothache: The most common dental emergency. This generally means a badly decayed tooth. As the pain affects the tooth's nerve, treatment involves gently removing any debris lodged in the cavity being careful not to poke deep as this will cause severe pain if the nerve is touched. Next rinse vigorously with warm water. Then soak a small piece of cotton in oil of cloves and insert it in the cavity. This will give temporary relief until a dentist can be reached.<br><br>At times the pain may have a more obscure location such as decay under an old filling. As this can be only corrected by a dentist there are two things you can do to help the pain. Administer a pain pill (aspirin or some other analgesic) internally or dissolve a tablet in a half glass (4 oz) of warm water holding it in the mouth for several minutes before spitting it out. DO NOT PLACE A WHOLE TABLET OR ANY PART OF IT IN THE TOOTH OR AGAINST THE SOFT GUM TISSUE AS IT WILL RESULT IN A NASTY BURN.<br><br>Swollen Jaw: This may be caused by several conditions the most probable being an abscessed tooth. In any case the treatment should be to reduce pain and swelling. An ice pack held on the outside of the jaw, (ten minutes on and ten minutes off) will take care of both. If this does not control the pain, an analgesic tablet can be given every four hours.<br><br>Other Oral Injuries: Broken teeth, cut lips, bitten tongue or lips if severe means a trip to a dentist as soon as possible. In the mean time rinse the mouth with warm water and place cold compression the face opposite the injury. If there is a lot of bleeding, apply direct pressure to the bleeding area. If bleeding does not stop get patient to the emergency room of a hospital as stitches may be necessary.<br><br>Prolonged Bleeding Following Extraction: Place a gauze pad or better still a moistened tea bag over the socket and have the patient bite down gently on it for 30 to 45 minutes. The tannic acid in the tea seeps into the tissues and often helps stop the bleeding. If bleeding continues after two hours, call the dentist or take patient to the emergency room of the nearest hospital.<br><br>Broken Jaw: If you suspect the patient's jaw is broken, bring the upper and lower teeth together. Put a necktie, handkerchief or towel under the chin, tying it over the head to immobilize the jaw until you can get the patient to a dentist or the emergency room of a hospital.<br><br>Painful Erupting Tooth: In young children teething pain can come from a loose baby tooth or from an erupting permanent tooth. Some relief can be given by crushing a little ice and wrapping it in gauze or a clean piece of cloth and putting it directly on the tooth or gum tissue where it hurts. The numbing effect of the cold, along with an appropriate dose of aspirin, usually provides temporary relief.<br><br>In young adults, an erupting 3rd molar (Wisdom tooth), especially if it is impacted, can cause the jaw to swell and be quite painful. Often the gum around the tooth will show signs of infection. Temporary relief can be had by giving aspirin or some other painkiller and by dissolving an aspirin in half a glass of warm water and holding this solution in the mouth over the sore gum. AGAIN DO NOT PLACE A TABLET DIRECTLY OVER THE GUM OR CHEEK OR USE THE ASPIRIN SOLUTION ANY STRONGER THAN RECOMMENDED TO PREVENT BURNING THE TISSUE. The swelling of the jaw can be reduced by using an ice pack on the outside of the face at intervals of ten minutes on and ten minutes off.<br><br>If you have any concerns about in which and also how you can employ [http://www.youtube.com/watch?v=90z1mmiwNS8 dentist DC], you can email us from our own webpage.
:''See [[Lyapunov stability]], which gives a definition of '''asymptotic stability''' for more general [[dynamical systems]]. All '''exponentially stable''' systems are also '''asymptotically stable.'''''
In [[control theory]], a continuous [[LTI system theory|linear time-invariant system]] is '''exponentially stable''' if and only if the system has [[eigenvalue]]s (i.e., the [[pole (complex analysis)|pole]]s of input-to-output systems) with strictly negative real parts. (i.e., in the left half of the [[complex plane]]).<ref>David N. Cheban (2004), ''Global Attractors Of Non-autonomous Dissipative Dynamical Systems''. p.&nbsp;47</ref> A discrete-time input-to-output LTI system is exponentially stable if and only if the poles of its [[transfer function]] lie strictly within the [[unit circle]] centered on the origin of the complex plane. Exponential stability is a form of [[asymptotic stability]]. Systems that are not LTI are exponentially stable if their convergence is [[bounded function|bounded]] by [[exponential growth|exponential decay]].
 
==Practical consequences==
 
An exponentially stable LTI system is one that will not "blow up" (i.e., give an unbounded output) when given a finite input or non-zero initial condition. Moreover, if the system is given a fixed, finite input (i.e., a [[Heaviside step function|step]]), then any resulting oscillations in the output will decay at an [[exponential growth|exponential rate]], and the output will tend [[asymptote|asymptotically]] to a new final, steady-state value. If the system is instead given a [[Dirac delta function|Dirac delta impulse]] as input, then induced oscillations will die away and the system will return to its previous value. If oscillations do not die away, or the system does not return to its original output when an impulse is applied, the system is instead [[marginal stability|marginally stable]].
 
==Example exponentially stable LTI systems==
 
[[Image:AsymptoticStabilityImpulseScilab.png|thumb|320px|The impulse responses of two exponentially stable systems]]
 
The graph on the right shows the [[impulse response]] of two similar systems. The green curve is the response of the system with impulse response <math>y(t) = e^{-\frac{t}{5}}</math>, while the blue represents the system <math>y(t) = e^{-\frac{t}{5}}\sin(t)</math>. Although one response is oscillatory, both return to the original value of 0 over time.  
 
===Real-world example===
 
Imagine putting a marble in a ladle. It will settle itself into the lowest point of the ladle and, unless disturbed, will stay there. Now imagine giving the ball a push, which is an approximation to a Dirac [[Dirac delta function|delta impulse]]. The marble will roll back and forth but eventually resettle in the bottom of the ladle. Drawing the horizontal position of the marble over time would give a gradually diminishing sinusoid rather like the blue curve in the image above.
 
A step input in this case requires supporting the marble away from the bottom of the ladle, so that it cannot roll back. It will stay in the same position and will not, as would be the case if the system were only marginally stable or entirely unstable, continue to move away from the bottom of the ladle under this constant force equal to its weight.
 
It is important to note that in this example the system is not stable for all inputs. Give the marble a big enough push, and it will fall out of the ladle and fall, stopping only when it reaches the floor. For some systems, therefore, it is proper to state that a system is exponentially stable ''over a certain range of inputs''.
 
==See also==
* [[Control theory]]
* [[State space (controls)]]
 
==References==
{{reflist}}
 
==External links==
* [http://www.princeton.edu/~ap/stability.pdf. Parameter estimation and asymptotic stability instochastic filtering], Anastasia Papavasiliou∗September 28, 2004
 
 
[[Category:Dynamical systems]]
[[Category:Stability theory]]
 
[[fr:Stabilité de Lyapunov#Les stabilités]]

Revision as of 07:55, 1 January 2014

See Lyapunov stability, which gives a definition of asymptotic stability for more general dynamical systems. All exponentially stable systems are also asymptotically stable.

In control theory, a continuous linear time-invariant system is exponentially stable if and only if the system has eigenvalues (i.e., the poles of input-to-output systems) with strictly negative real parts. (i.e., in the left half of the complex plane).[1] A discrete-time input-to-output LTI system is exponentially stable if and only if the poles of its transfer function lie strictly within the unit circle centered on the origin of the complex plane. Exponential stability is a form of asymptotic stability. Systems that are not LTI are exponentially stable if their convergence is bounded by exponential decay.

Practical consequences

An exponentially stable LTI system is one that will not "blow up" (i.e., give an unbounded output) when given a finite input or non-zero initial condition. Moreover, if the system is given a fixed, finite input (i.e., a step), then any resulting oscillations in the output will decay at an exponential rate, and the output will tend asymptotically to a new final, steady-state value. If the system is instead given a Dirac delta impulse as input, then induced oscillations will die away and the system will return to its previous value. If oscillations do not die away, or the system does not return to its original output when an impulse is applied, the system is instead marginally stable.

Example exponentially stable LTI systems

The impulse responses of two exponentially stable systems

The graph on the right shows the impulse response of two similar systems. The green curve is the response of the system with impulse response , while the blue represents the system . Although one response is oscillatory, both return to the original value of 0 over time.

Real-world example

Imagine putting a marble in a ladle. It will settle itself into the lowest point of the ladle and, unless disturbed, will stay there. Now imagine giving the ball a push, which is an approximation to a Dirac delta impulse. The marble will roll back and forth but eventually resettle in the bottom of the ladle. Drawing the horizontal position of the marble over time would give a gradually diminishing sinusoid rather like the blue curve in the image above.

A step input in this case requires supporting the marble away from the bottom of the ladle, so that it cannot roll back. It will stay in the same position and will not, as would be the case if the system were only marginally stable or entirely unstable, continue to move away from the bottom of the ladle under this constant force equal to its weight.

It is important to note that in this example the system is not stable for all inputs. Give the marble a big enough push, and it will fall out of the ladle and fall, stopping only when it reaches the floor. For some systems, therefore, it is proper to state that a system is exponentially stable over a certain range of inputs.

See also

References

43 year old Petroleum Engineer Harry from Deep River, usually spends time with hobbies and interests like renting movies, property developers in singapore new condominium and vehicle racing. Constantly enjoys going to destinations like Camino Real de Tierra Adentro.

External links

fr:Stabilité de Lyapunov#Les stabilités

  1. David N. Cheban (2004), Global Attractors Of Non-autonomous Dissipative Dynamical Systems. p. 47